Genesis of a Victoire frame : step 3

Genesis of a Victoire frame : step 3

The Victoire MTB frame that will be exposed on the Formula booth at the Roc D'Azur 2015 went to paint this afternoon. During this morning we did all the facing and controls and we now cannot wait to build this baby! 

You can check the photos of the last steps below :

After welding, all the tubes tend to ovalize. To put all the bearings and parts into the frames, we need to face and ream every corner of the frame. Bottom bracket, headset and seat tube are controled and hand machined. To fit our made in France mind, we only use made in France tools mabe by Var!
 

Catégorie: 

Subscribe to our mailing list

* indicates required
Langue